mtlb_hold

Matlab hold emulation function

Description

There is no Scilab equivalent function for Matlab hold but there are equivalent instructions.

The function mtlb_hold(flag) is used by mfile2sci to replace hold flag when it was not possible to know what were the inputs while porting Matlab code to Scilab. This function will determine the correct semantic at run time. If you want to have a more efficient code it is possible to replace mtlb_hold calls:

  • If flag is equal to “on” mtlb_hold(flag) may be replaced by set(gca(),”auto_clear”,”off”)
  • If flag is equal to “off” mtlb_hold(flag) may be replaced by set(gca(),”auto_clear”,”on”)

Caution: mtlb_hold has not to be used for hand coded functions.

See Also

Table Of Contents

This Page